Meguiar's Hyper-Wash (3,78 l)

Meguiar's Hyper-Wash (3,78 l)

When used in a foamer, adjust the dilution ratio to 20:1 to achieve a snow foam that effectively and at the same time completely gently prewashes the bodywork. Even with heavy pollution, it is enough to rinse the car from loose dirt, spray the shampoo on the car, let it work for 5 minutes and then wash it by hand using the usual procedure without rinsing. With this procedure, you will achieve a perfect pre-wash, effective dirt removal, strengthening of the shine and keeping the protective layer intact.

Tips for washing your car

• Careless washing is the main source of paint damage. Improper hand washing or visiting gantry/brush washers will inevitably result in scratches and damage to the paintwork.
• Always wash in such a way as to eliminate the risk of damaging the paint.
• Always use only your own proven shampoo and not over-the-counter shampoos whose origin is unknown to you and whose washing properties have not been carefully verified.
• Do not use dishwashing detergents, household detergents, non-contact or active cleaners and foams, degreasers, solvents and other detergents. These cleaners are usually not gentle on the protective wax layer or polishing oils on the paint surface, they dry it out and leave it exposed and without any protection. Unprotected paint will very soon start to degrade on the surface, its oxidation and loss of gloss will begin to show, and it is very dangerously exposed to the adverse effects of the surrounding environment and is significantly more susceptible to mechanical and chemical damage.
• The water you wash your car with should be as close to body temperature as possible.
• Use the two-bucket method or a Meguiar's bucket with a Grit Guard liner .
• Do not use foam sponges or gloves with large braided fibers. These sponges and gloves cannot effectively absorb dirt, and using them can scratch the paint. Use only a gentle washing glove with very fine bristles made of microfiber or natural lamb's wool, which catch small dirt and absorb it.
• Always dry your car after washing! This will prevent the formation of water spots caused by minerals contained in the water. In addition, active drying prevents the redeposition of dust during spontaneous drying.
• For drying, use only the high-quality, extremely absorbent microfiber drying towel X1802 Meguiar's Supreme Drying Towel or X2000 Meguiar's Water Magnet , or the superior natural chamois X2100 Meguiar's Natural Chamois . Locally, you can dry hard-to-reach areas with compressed air (watch out for re-contamination with oil that can spray out of the nozzle!). We do not recommend drying with a silicone squeegee, which can catch a grain of dust and scratch the paint.
• Meguiar's shampoo does not need to lather at all when washing and still has all its great properties and is 100% gentle. Always mix the shampoo into the water, moreover, there is no need to lather the shampoo!

Recommended procedure for washing a car

• Rinse your car from loose dirt with pressurized water or a sponge from the bottom up. The lower parts of the car are the most dirty, so when rinsing from the bottom up, the water acts on the dirtiest places for the longest time, and thus soaks the dirt for the longest time. In addition, all the dirt from the higher parts flows down and thus helps to remove soaked dirt from thresholds, wheels or chassis parts.
• If you want to pre-wash the car, dilute the shampoo in the foamer in a ratio of 20:1.
• The shampoo creates a rich snowy and stable foam, which you spray on the entire surface of the car and leave for 5 minutes or as needed.
• The action of the foam soaks up stubborn dirt, e.g. dried insects or road dirt, and achieves a perfect pre-wash, strengthens the shine and keeps the protective layer intact.
• Do not rinse the car from the foam!
• Dilute the shampoo in a 400:1 ratio in the bucket.
• Afterwards, wash the entire body with shampoo by hand from top to bottom, i.e. from the cleanest parts to the dirtiest.
• Always wash the glove thoroughly when soaking in the bucket to remove any dirt and you haven't put it back on the paint.
• Rinse the shampoo from the body using pressurized water or a sponge from top to bottom. The running water will help you remove the shampoo even from hard-to-reach places.
• Finally, rinse the car again slowly from top to bottom, but this time only with a very thin stream of water flowing freely from the hose without a pressure attachment. With this step, up to 80% of the remaining water can be removed from the varnish, making subsequent drying much easier.
• Dry the car with a high-quality, extremely absorbent microfiber drying towel X1802 Meguiar's Supreme Drying Towel or X2000 Meguiar's Water Magnet , or superior natural chamois X2100 Meguiar's Natural Chamois .
• If necessary, reinforce the protective wax layer with one of Meguiar's quick waxes.

Product features

• Rich, durable foam ensures fantastic washing results.
• Extremely concentrated.
• Biodegradable.
• Great for use with mixing machines.
• Also suitable for washing matte varnishes.
• Application methods: wash and rinse with water.
• Dilution: 400:1 (hand wash), 20:1 (foamer).
• Paintable, VOC compatible.

Product comments

Evaluation

• Car cosmetics Car exterior maintenance Car wash Car shampoos
• MEGUIAR'S car care products